11/5/2022 0 Comments 8.3.1.2 packet tracer eigrp![]() ![]() ![]() Step 3: Verify end-to-end connectivity PC1, PC2 and PC3 should now be able to ping each other. On R2, enter the command you listed for 2a and answer the following questions: How many routers are sharing routing information with R2? Where is this information located under? What is the maximum hop count? What command displays the parameters and other information about the current state of any active IPv4 routing protocol processes configured on the router? b. Step 2: Display the EIGRP routing protocol parameters. The output for R1 should look similar to the following: IP-EIGRP neighbors for process 1 H Address Interface All three routers should have two neighbors listed. Which command displays the neighbors discovered by EIGRP? b. Part 2: Verify EIGRP Routing Step 1: Examine neighbor adjacencies. Note: Prior to IOS 15 auto-summary had to be manually disabled. Therefore, disable automatic summarization on each router. ![]() The topology contains discontiguous networks. 8.3.1.2 PACKET TRACER EIGRP SOFTWARER1(config-router)# passive-interface g0/0 Moshammad Sharmin Akter, Mohammad Anwar Hossain, Analysis and Comparative Study for Developing Computer Network in Terms of Routing Protocols Having IPv6 Network Using Cisco Packet Tracer, Software Engineering. Configure the LAN interfaces to not advertise EIGRP updates. On each router, configure EIGRP to advertise the specific directly connected subnets. However, this command is not supported on Packet Tracer, which is why I have configured R1 to advertise a summary address to both R2 and R3. How can you tell the difference between subnet addresses and interface addresses?ī. In such a case, we will just disable split horizon on R1’s S0/1/0 using the no ip split-horizon eigrp command. Use the show ip route command to display the directly connected networks on each router. Step 2: Advertise directly connected networks. R1(config)# router eigrp 1 What is the range of numbers that can be used for AS numbers? Note: Packet Tracer currently does not support the configuration of an EIGRP router ID. Enable the EIGRP routing process on each router using AS number 1. Part 1: Configure EIGRP Step 1: Enable the EIGRP routing process. You will then verify your EIGRP configuration using a variety of show commands and testing end-to-end connectivity. In this modern era the computer communication network is growing rapidly, Computer communication networks are based on a technology that provides the technical infrastructure, where routing protocols are used to transmit packets across the Internet. Packet Tracer – Configuring Basic EIGRP with IPv4īackground In this activity, you will implement basic EIGRP configurations including network commands, passive interfaces and disabling automatic summarization. Analysis of RIPv2, OSPF, EIGRP Configuration on router Using CISCO Packet tracer. Objectives Part 1: Configure EIGRP Part 2: Verify EIGRP Routing Packet Tracer – Configuring Basic EIGRP with IPv4 Topology ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |